Skip to main content

Resetting the System Management Controller (SMC)

The System Management Controller (SMC) is a chip on logic board that controls all power
functions. If computer is experiencing any power issue, such as not starting up, not displaying
video, sleep issues, or fan noise issues, resetting SMC may resolve it. To reset SMC on an iMac:

1. From Apple menu, choose Shut Down (or if the computer is not responding, hold power
button for approximately ten seconds until it powers off).

2. Unplug all cables from computer, including power cord.

3. Press and hold the power button for 5 seconds.

4. Release the power button.

5. Attach the computer’s power cable, making sure power button is not being pressed.
Note: If you press the power button while inserting the power cord, the iMac will enter a
mode in which the fans run at full speed.

6. Press the power button to turn on the computer.
Labels:

Comments

Post a Comment

Popular posts from this blog

Run Apple Service Error Diagnostic

Run Apple Service Error Diagnostic  Run Apple Service Diagnostic version 3S135 to determine if any thermal sensors or blowers are malfunctioning. If ASD is not available, run Apple Hardware Test version 3A189 by holding down the D key during startup. When a test reports an error, reseat appropriate connections. If issue persists, replace the corresponding part (sensor, blower, logic board, video card, or power supply). See Apple Hardware Error code chart below for correlation between error code, affected sensor, sensor location, and additional checks to perform. AHT Error code Suspected part and Location Suggested Action Notes 4SNS/1/C0000008: TA0P - xxx mbient temp sensor damaged or disconnected from logic board. Verify sensor cable is securely connected to the top edge of the logic board and attached to the left speaker housing. Replace sensor cable if damaged. All fans ramp at full speed if sensor is disconnected. 4SNS/1/C0000008: T00p-xxx ODD temp sensor ...
Post a Comment
Read more

How to Access Terminal via Recovery Mode for Mac

Access Terminal via Recovery Mode for Mac Some more advanced Mac troubleshooting and diagnostics techniques require a user to access the Terminal from Mac OS Recovery Mode. We’ll show you how to quickly access the command line while a Mac is booted into Recovery Mode. For some quick background, on a normally booted Mac, the Terminal application is found within the /Applications/Utilities/ folder, and it can be accessed directly through the folder hierarchy or by using Spotlight to search for and launch Terminal app. But Recovery Mode does not have the same applications directory access, nor does it have Spotlight or Launchpad. Nonetheless, accessing Terminal from Recovery boot mode is easy. Accessing the Command Line in Recovery Mode on a Mac     Boot into Mac OS Recovery Mode as usual by holding down the Command and R keys during system start     Choose the language as usual (if applicable)     At the “MacOS Utilities” screen, pull do...
Post a Comment
Read more

how to LED Startup Sequence in iMac 2015

LED #1 = Power available. If no LED is visible: • Verify AC source • Verify known-good AC cable is connected • Verify cable connection between AC inlet and power supply • Verify cable connection between power supply and logic board • Verify power supply LED #1 + LED #2 = Power available, and system is powered on. If second LED is not visible when power button is pressed: • Verify power button connection to logic board • Verify power button functionality • Verify cable connection between power supply and logic board • Verify power supply • Verify logic board LED #1 + LED #2 + LED #3 = Power available, system is powered on, and video card found . If third LED is not visible after power on: • Verify that MXM video card is seated properly • Verify logic board LED #1 + LED #2 + LED #3 + LED #4 = Power available, system is powered on, video card found, and internal LCD found. If fourth LED is not visible after power on: • Verify cable connections between LCD pane...
Post a Comment
Read more